EasyManua.ls Logo

Tusk UTV Rear Window User Manual

Default Icon
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
Tusk UTV Rear Window Instructions
Polaris RZR XP 1000 and XP4 1000
Thank you for purchasing the Tusk UTV Rear Window. Please read through all the
instructions and examine the rear window to become more familiar with the straps and buckles
used for mounting.
1. Position the Tusk UTV Rear Window on the
back (outside) of the roll cage with the window
stitching and female buckles facing inward
toward the cockpit. Attach the two Velcro straps
on the top horizontal roll bar (see fig. 1).
2. Attach the top corners of the rear window.
Wrap the material around the bend in the roll
cage and attach each strap as shown in figure 1.
Leave straps loose.
3. Remove the seats for easy access to the back
panels/engine cover. Position the bottom of the
rear window between the seats and
engine cover (see fig. 2).
4. Loop the upper side straps
(located near the seatbelt mounting
bracket) around the seat belt
mounting bracket as seen in figure
3. Thread the strap back through
the buckle on the rear window (see
fig. 4). Leave somewhat loose at
this point.
Question and Answer IconNeed help?

Do you have a question about the Tusk UTV Rear Window and is the answer not in the manual?

Tusk UTV Rear Window Specifications

General IconGeneral
BrandTusk
ModelUTV Rear Window
CategoryAutomobile Accessories
LanguageEnglish

Summary

Tusk UTV Rear Window Installation Guide

Initial Positioning and Top Strap Attachment

Position the rear window on the roll cage and attach top Velcro and corner straps loosely.

Bottom Window Placement

Position the bottom of the rear window between the seats and engine cover.

Securing Upper Side Straps

Loop upper side straps around seat belt mounting brackets.

Lower Strap Installation and Bottom Fastening

Routing Lower Side and Corner Straps

Route lower side straps around the B-pillar and bottom corner straps under the door hinge bar.

Attaching Bottom Plastic Hooks

Slide bottom plastic hooks under the back panel/engine cover and reinsert male buckles.

Final Tightening and Securing

Tightening All Straps

Evenly tighten all straps from top to bottom, reinstall seats, and check for security.

Transportation Warning

Window removal during transportation is recommended for longevity.

Related product manuals