What does a flashing decimal mean on Tuthill SOTERA 825 Measuring Instruments?
A flashing decimal on your Tuthill Measuring Instruments means the current total has rolled over. Reset the display to zero by pressing button 2.
What does Err2 mean on Tuthill SOTERA 825 Measuring Instruments?
The Err2 error code on your Tuthill Measuring Instruments indicates a bad eeprom, which means you should replace the electronics.
General| Brand | Tuthill |
|---|---|
| Model | SOTERA 825 |
| Category | Measuring Instruments |
| Language | English |
Details flow ports, range, pressure, temperature limits, accuracy, units of measure, and range.
Lists construction materials and provides physical dimensions of the meter.
Lists compatible fluids and provides a warning about incompatible fluids.
Covers warnings on herbicides, fluid handling, pressure limits, misuse, and flammable fluids.
Specific warning regarding the removal of the PC board and potential warranty void.
Describes the nutating disk mechanism, magnetic coupling, and digital display.
Instructions for using Teflon tape, determining flow direction, and threading connections.
Steps to change the position of the meter readout display.
Critical DANGER notice regarding the use with fluids below 100°F flashpoint.
Lists optional components such as EPDM seals and SAE threaded ports.
Details the functions of the ON, RESET TO ZERO, and CHANGE CAL FACTOR buttons.
Covers priming the meter, turning it on, resetting totals, and display inactivity.
Explains the CAL factor concept and provides a table of suggested settings for common fluids.
Detailed steps for calibrating the meter, including setting CAL factor, priming, and filling.
Instructions on how to adjust the CAL factor based on meter readings (high or low).
Step-by-step instructions on how to change the meter's calibration factor.
Guidance on how to replace the meter's batteries, including warnings.
Covers flushing between uses and detailed steps for thorough meter cleaning.
General advice on replacing damaged meter components.
Recommendations for storing the meter in a cool, dry place.
Lists common problems, their possible causes, and recommended solutions for meter operation.
Detailed list of components and part numbers for the 825/850 meters.
Information on available repair kits for the meters.
Procedure for changing units and setting special units.
Instructions on how to reset the accumulated total on the meter.
Guide on how to check the meter's current calibration accuracy.
Explanation of the FLSH mode and caution against leaving the meter in this state.
Step-by-step guide for recalibrating the meter using clean water.
Instructions for calibrating the meter with fluids other than water.
Graphs to help select calibration factors based on fluid viscosity.
To Next Page
