IMPORTANT: The collector/dispenser bottle must be properly placed,
with its cap removed and filter cup in place, for proper water collection.
DO NOT remove collector/dispenser bottle while Distiller is operating.
NOTE: At the end of the distillation cycle (about 4.5 hours), Distiller
will shut off automatically and “Start” light will go out. The fan will
continue to operate for a few minutes.
15. Unplug cord from wall outlet when not in use.
16. DISCARD FIRST GALLON of distilled water as it may contain
some harmless matter from manufacturing and/or packaging.
17 Rinse boiler thoroughly before refilling.
IMPORTANT: Wipe off all water deposits inside the Distiller chassis and
on the outside of the boiler before each distillation cycle.
NOTE: The collector/dispenser bottle will not fill completely. The collec-
tor was designed to hold 1 gallon of water and allow additional space so
that the carbon filter does not remain in contact with the distilled water.
Once distillation cycle is complete, the water bottle may be placed in
refrigerator and used to dispense the distilled water. The filter cup may be
left in or removed and stored in the refrigerator in a sealed plastic bag or
other airtight container. Secure cap onto the bottle to avoid spilling. The
cap must be opened slightly before dispensing water. It is recommended
that the bottle NOT be placed in a freezer as handle may become brittle
and crack.
NOTE: Approximately 5 ounces (150 ml) of water will remain in boiler
at the end of the distillation cycle. This feature reduces scale deposits in
the boiler.
WARNING: To prevent personal injury or electric shock, DO NOT
immerse the Distiller, its boiler, its cord or plugs in water or other liquid.
8
Figure F
Filter Cup
Dispensing
Valve
Boiler
Collector/Dispenser
Bottle
PREPARING FOR FIRST TIME USE
Clean Collector/Dispenser Bottle
• Ensurethedispensingvalve(g.B)isinstalledandtightened.
• Fillbottleapproximatelythreefourthsfullwithtapwater.
• Addoneortwodropsofdishdetergent.
• DO NOT install filter cup at this time.
• Sealbottleopeningwithcap.
• Shakevigorouslyanddrain.
• Rinsethoroughly.
Sanitize Collector/Dispenser Bottle
• Add6ounces(180ml)of3percenthydrogenperoxidetobottle.
• Fillwithhotdistilledortapwater.
• DO NOT install the filter cup at this time.
• Sealbottleopeningwithcap.
• Shakevigorouslyandletstandfor20minutes.
• Drainandrinsethoroughly.
Sterilize and Rinse Carbon Filter Cup
Before installing, fully immerse new filter cup in distilled water for about
five minutes. Then sterilize filter cup by fully immersing in boiling water
for about five minutes. Allow filter to cool before handling. Pour 1 to 2
cups distilled water through filter cup to rinse away any small, harmless
carbon fines (dust). Water draining from the filter cup may contain black
dust. This is typical. The carbon dust is formed as a result of production,
packaging and shipping of filter cup.
Install Filter Cup
Place sterilized filter cup into opening
of collector/dispenser bottle. There is
a label packed with replacement filter
cups. Write in installation date as a
replacement reminder.
Replace Filter Cup
The filter cup should be replaced
every two months or after 60-80
gallons of water processed (which-
ever comes first). Replace more often
should the distilled water begin to
have an unwanted taste or odor.
Discard first gallon of distilled water
as it may contain small, harmless
carbon fines. Order replacement filters
from the outlet where you purchased
your distiller.
5
Collector/Dispenser Bottle
Figure B
To Next Page
Loading...