20
4. Clutch lever
Use the clutch lever to disengage the drive to the rear
wheel while shifting the gears. Squeezing the lever
towards grip disengages the drive.
5. Pass by switch
Press the switch to flash the headlamp high beam.
It is used to give signal to the vehicles coming from
opposite direction while overtaking other vehicles
during day. If the switch is pressed while the
headlamp is turned ‘ON’ and glowing in high beam,
there will not be any change in the beam of headlamp.
6. Beam control switch
The headlamp beam (high/low) can be controlled by
pressing the beam control switch.
Press the switch towards ‘ ’ to turn-on the
headlamp high beam or press the switch towards
‘ ’ to turn-on the headlamp low beam.
Always use the appropriate turn signal lamps when you
intend to change lanes or take turns. Be sure to switch it
‘OFF’ after negotiating the lanes or turns.
Use appropriate headlamp beam ‘high / low’ as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders.
Headlamp glows only when the engine is in running.
To Next Page
Loading...
