19
Note
When you switch ‘ON’ the ignition, the pump priming
noise may be heard, which is normal. Avoid frequent
switch ‘OFF & ON’ of ignition to avoid unnecessary
actuation of fuel pump.
Digital speedometer‘s back illumination, position lamp,
tail lamp and number plate lamp glows automatically
once the ignition is turned ‘ON’ without activating any
other switches. The headlamp starts to glow along with
above lamps once the engine is started.
When the ignition switch is turned ‘ON’, the speedometer
performs self diagnostic cycle. Wait till the ‘0 km/h’
details appears on the display.
HANDLE BAR LEFT SIDE
1. Info switch
Info switch ‘ ‘ is used to accept or reject incoming
call, erase the stored value, voice assist invoking in
cluster etc. (Refer page no. 32, 39 and 45 for
details)
2. Horn switch
Press the switch ‘ ’ to operate the horn.
3. Turn signal lamp switch
Slide the turn signal lamp switch to left ‘ ’ or right
side ‘ ’ to operate the respective turn signal lamps
(LH/RH). Press the switch to turn ‘OFF’.
23
4
6
5
1
To Next Page
Loading...
