Fitting the waste disposer
all models except Westminster
Before mounting the disposer ensure that the hinge faces the front. The unit is supplied with a right hand
outlet, though machines can be supplied with a left hand outlet. A right hand outlet machine can be made
into a left hand outlet machine simply by unscrewing and re-aligning the carrier plate. In this case please
telephone the manufacturers for a suitable label. The discharge pipe must not be plumbed in front of the
disposer; this will enable the unit to be removed easily if servicing is required. Care must be taken to
ensure that the trap level is below the grinding chamber as it is essential that the chamber
drains down completely.
1. First fi t the outlet elbow to unit by placing gland nut, ring and rubber seal over outlet stub.
Ensure sloping side of rubber seal faces away from unit. Offer up outlet elbow and tighten.
2. Remove splashguard or seal from the unit.
3. Hang unit by hinge pin of the carrier plate on the suspension plate.
8
To Next Page
Loading...