Twin Tec 2005 User Manual

Daytona Twin Tec LLC, 933 Beville Road, Suite 101-H, S. Daytona, FL 32119 2005 Single Fire Coil
(386) 304-0700 www.daytona-twintec.com
4/2007
Page 1
Twin Tec
Installation Instructions for
Single Fire Coil P/N 2005
CAUTION: CAREFULLY READ INSTRUCTIONS BEFORE PROCEEDING.
NOT LEGAL FOR USE OR SALE ON POLLUTION CONTROLLED VEHICLES.
OVERVIEW
The Twin Tec P/N 2005 coil is intended for
Harley-Davidson
®
applications using aftermarket single
fire ignitions such as the Twin Tec Models 1005-1007,
Crane HI-4 and Dyna 2000 series. The Twin Tec P/N
2005 contains two independent high output coils in a
housing that fits the stock mounting location and coil
cover for most applications. Do not use this coil for any
breaker points, Dyna-S series, or Harley-Davidson
®
Twin Cam 88
®
applications.
INSTALLATION
1. Turn off the ignition switch and disconnect the
battery ground cable before proceeding.
2. For Twin Tec ignitions, use the hookup shown in
Figure 1 or 2. You can use the same hookup for
Crane and Dyna modules except that the wire
color codes are different:
Crane HI-4 Series
Front Cylinder Coil- Black
Rear Cylinder Coil- White
Coil+ (Module Power) Red
Dyna 2000 Series
Front Cylinder Coil- Blue
Rear Cylinder Coil- Pink
Coil+ (Module Power) White
Figure 1 – Twin Tec Model 1005 Single Fire Wiring Diagram
RPM
+
_ _
5
0
9
8
6
7
3
1
2
4
6
5
2
4
3
8
9
0
7
1
6
5
2
4
3
8
9
0
7
1
6
5
2
4
3
8
9
0
7
1
Model 1005
STATUS
VOES
MODE
SELECT X1000
RPM LIMITADVANCE
SLOPE
X100
ADJUST
TwinTec
Internal Ignition
MODE SETTINGS FOR SINGLE FIRE
2 STREET ADVANCE CURVES, MULTI-SPARK DISABLED
3 STREET ADVANCE CURVES, MULTI-SPARK ENABLED
6 RACE ADVANCE CURVES, MULTI-SPARK DISABLED
7 RACE ADVANCE CURVES, MULTI-SPARK ENABLED
ENGINE
STOP/RUN
SWITCH
OPTIONAL VOES
(VACUUM SWITCH)
WHITE/BLACK
SINGLE FIRE COIL
WHITE/BLACK
PURPLE/WHITE
TAPE UP WIRE IF
VOES NOT USED
BLUE
TO FRONT
SPARK
PLUG
TO REAR
SPARK
PLUG
OPTIONAL TACH
FEMALE TERMINAL
MALE TERMINAL
WEATHER PACK CONNECTORS
BROWN
OPTIONAL CABLE CONNECTED TO
BROWN TACH WIRE DURING PC LINK
TO PC
SERIAL
PORT
TO
+12V
PINK
For Twin Tec Model 1005S, refer to
ignition installation instructions.

Twin Tec 2005 Specifications

General

Brand	Twin Tec
Model	2005
Category	Motorcycle Accessories
Language	English

Summary

Twin Tec Single Fire Coil P/N 2005 Installation

Important Safety and Legal Disclaimers

Cautionary notes on usage and legality for pollution-controlled vehicles.

Product Overview and Compatibility

Details the Twin Tec P/N 2005 coil for Harley-Davidson applications and compatible ignitions.

Initial Installation Steps

Instructions to turn off ignition and disconnect the battery ground cable before proceeding.

Wiring for Twin Tec and Other Ignitions

Wiring diagrams and color codes for Twin Tec, Crane HI-4, and Dyna 2000 series.

Model 1006/1007 Wiring Diagram

Shows wiring for Twin Tec Model 1006/1007 single fire ignition systems.

Terminal Greasing and Plug Wire Recommendations

Instructions for dielectric grease application and suitable spark plug wires.

Critical Ignition System Warnings

Warnings against cranking with disconnected spark plug wires or testing while running.