4. Q&A of Clearance adjustment
EN
FAQ
18
FAQ
19
3. Q&A of Screen
Q1：When the screen does not show.
A1：As shown in the figure -2. Pls check if the screen cable is loose and re-tighten,Or change the line
sequence restart.
A2： The screen line is loose: There will be a vibration during the transportation of the machine. The vibration
may cause the wire plug inside the machine to loosen and cause poor contact or no contact. At this time,
the screen of the machine will turn white and not work properly. Pls check if the line have problems firstly.
A3：Motherboard or screen problem: If there is no problem with the screen line,then there is a problem with
the motherboard or the screen. If there are multiple machines, you can replace the "bad" with a normally
displayed screen. if the good screen can be displayed normally, it is a problem with the original screen,
if not, there is a problem with the motherboard. If you encounter this problem, you can contact the
after-sales customer service.
figure - 4figure - 3
We have reserved enough space for adjusting the leadscrew. If you feel a slightly noticeable gap in the screw
travel after using it for a whilePlease don't worry, this is caused by the wear of the brass nut or the loosening of
the screw. As shown in the figure-3. The solution is as follows:
1. Remove the sheet metal on the side.
2.Loosen the screws and tighten them again to solve the problem.XYZ axis adjustment method is the same.
To Next Page
Loading...
