Need help?Do you have a question about the TWO TREES TS2 and is the answer not in the manual?
General| Laser Power | 10W |
|---|---|
| Connectivity | USB, Wi-Fi |
| Software Compatibility | LaserGRBL, LightBurn |
| Laser Output Power | 10W |
| Wavelength | 450nm |
| Engraving Accuracy | 0.01mm |
| Focusing Method | Fixed Focus |
| Laser Type | Diode Laser |
| Connection | USB, Wi-Fi |
| Cooling System | Air Cooling |
| Engraving Area | 450mm x 450mm |
| Supported Materials | Wood, acrylic, leather, fabric, paper, bamboo, plastic |
| Focal Spot Size | 0.08mm x 0.08mm |
| Input Voltage | 100-240V AC |
| File Format | BMP, JPG, PNG |
| Engraving Speed | up to 10000mm/min |
| Power Supply | 24V 5A |
Provides caution and essential safety guidelines for operating the laser engraving machine, emphasizing handling precautions and material compatibility.
Details the assembly process for the front frame, back frame, and left Y-axis frame using specific screw bolts.
Explains how to mount the timing belt and idler pulley onto the left Y-axis frame, emphasizing proper belt positioning.
Describes how to adjust the tensioner for the left Y-axis, including notes on preventing obstruction or looseness.
Covers the installation of the right Y-axis frame, specifying the required components and screw bolts.
Details the installation of the timing belt and idler pulley for the right Y-axis frame, stressing correct belt placement.
Explains the process of adjusting the tensioner for the right Y-axis, with warnings about over-tightening.
Details the installation of the X-axis crossbeam parts, specifying screw bolts and emphasizing alignment for optimal performance.
Instructs on how to install the laser module, specifying the required screws for secure attachment.
Guides the installation of the protective cover for the laser module, detailing the necessary screws.
Allows adjustment of image attributes like sharpness, brightness, and contrast via a preview window.
Covers the selection of engraving modes such as 'Line-to-line Tracking' and '1Bit Shaking' for different purposes.
Guides on saving the configured GCODE file to a TF card for use with the engraver.
Guides on selecting correct serial number and baud rate for establishing a stable connection with LaserGRBL software.
Details launching LightBurn software and inputting custom key parameters within the console for device connection.
Introduces MKSLaserTool functions and guides on setting up a Wi-Fi connection for the machine.
Provides a cautionary guide on flashing motherboard firmware using the MKS ESP32 Download Tool, detailing file selection and parameter input.
To Next Page
