Tyco BTEL-3G - Device Status and User Menu; Status LEDs; User Menu Navigation; Programming Methods

9
3G/2G Telephone dialler
EN
ENGLISH
II
II
I
NOTE - The BTEL-3G is guaranteed to function only if the device has been installed and programmed
by qualified personnel.
Status LEDs
GREEN — The three green LED’s show the strength of GSM reception.
If ON, shows optimal GSM reception: it turns on only when the LEDs and are also lit.
If ON, the reception is good: it turns on only when the LED is lit.
If OFF, indicates that the GSM network is NOT available. If this LED is lit, the network signal is low but sufficient for
voice calls.
RED — This LED is normally OFF. If it lights up, this indicates a malfunction: call the installer.
YELLOW - If ON it means a call (either incoming or outgoing) is taking place on the GSM network.
RED - If solid lit it indicates that factory data are being loaded or programming is under way.
It blinks three times when the BTEL-3G receives a valid programming SMS.
User menu
The User menu allows you to use the BTEL-3G. The User menu can be accessed either with the keypad or remotely. A block
diagram of the User menu is shown below. The symbolËindicates the menu items that can be accessed with the keypad; the
phone symbol (indicates the menu items that can be accessed remotely.
UserMenu
<UserCode>
<UserCode>
<UserCode>
(Fordifferentformsof
accessseethe
respectivesections)
for Dialer
Parameters
Management
for Block
Calls
for Change
Code
for PhoneBook
Management
for Dial
Number
for Exit
for Output
Management
for Monitor
Input
for Environment
Listen
Management
for Back
for WritePhone
Book
for Delete
for ReadPhone
Book
for Back
Or:
II
II
I
When you are in the user menu, input activations are placed in the queue and handled after you exit
from the menu.
Programming by keypad
ËË
ËË
Ë
The BTEL-3G parameters can be programmed locally with a keypad. For clear and quick programming, a voice menu
provides support. When programming by keypad, select the parameter by pressing a series of keys, and then enter the value
for that parameter. Press the 9 key (the f key in the phone book settings menu) to exit from the current menu and go back
(if no keys are pressed, the voice messages for the menu level will be repeated 3 times before returning to the previous level).
Press the e key to enter the data. If you know the keypad sequence to press, to speed up programming, you can type the
sequence while the voice menu message is being played without having to wait for the whole message.