Need help?Do you have a question about the Tykma Zetalase and is the answer not in the manual?
General| Type | Laser Marking System |
|---|---|
| Laser Type | Fiber Laser |
| Wavelength | 1064 nm |
| Laser Power | 20W, 30W, 50W |
| Engraving/Marking Area | 100mm x 100mm to 300mm x 300mm |
| Resolution | 0.001mm |
| Connectivity | Ethernet, USB |
| Operating Voltage | 110-240 VAC, 50/60 Hz |
| Marking Speed | Up to 7000mm/s |
| Cooling Method | Air Cooling |
| Operating Temperature | 15-35°C |
| Weight | Varies by model |
Discusses common laser hazards, light reflections, and their safety implications.
Details how laser radiation impacts eyes and skin, including specific wavelength effects.
Covers MPE, NHZ, engineering/electrical controls, and administrative procedures.
Focuses on protective eyewear, administrative controls, warning signs, and conclusions.
Procedure for inspecting and replacing the cooling fan filter.
Instructions for cleaning the laser focusing lens using approved solutions.
Guidelines for lubricating the Motor Driven BiSlide Z-Axis assembly.
To Next Page