Initital set-up process
When activating h1 for the very first time, it is necessary to program a number of basic settings:
1. Set the region (Europe, USA, Other). Use the Up and Down arrows and press OK to confirm
your selection.
Select language. Use the Up and Down arrows and press OK to confirm your selection.
3. Select the relevant product (sauna, steam bath, Combi Compact). Use the Up and Down
arrows and press OK to confirm your selection.
4. Set the desired running time (1–23 hours for steam room; 1–12 hours for sauna) and press
OK to confirm
5. Set the current time and press OK to confirm.
Start
To start the sauna heater/steam generator, move your hand in front of the screen. The screen
will then light up The On/Off symbol will be highlighted Press OK The small On/Off icon will
then light up in the status display (5) to indicate that the sauna heater/steam generator has
been switched on. If the On/Off button (1) is not illuminated, press the Up arrow to step to the
right position. To switch off, step to (1) and press OK.
While the sauna heater/steam generator is in operation, the current temperature and time will
be displayed unless any alterations are made to the settings.
When the sauna heater/steam generator is switched off, the illumination in the control panel
will fade. It can be automatically reactivated by moving your hand in front of the panel.
Setting the desired bathing temperature
Press the Up or Down arrow to highlight the temperature symbol (2) and press OK. Set the
desired temperature using the Up/Down arrows and then confirm this by pressing OK.
When using h1 with a Combi Compact heater, remember that when the temperature set is
higher than 70°C, priority is given to heating up the sauna room. When the temperature set is
lower than 70°C, priority is given to producing steam. It is possible to alter these priorities in the
settings menu.
14
To Next Page
Loading...
