Tylo H1 - Cleaning; Display; Service; Vibration

Vibration
Here you can choose whether or not you wish the panel to vibrate slightly when a button is
pressed.
Service
Under the service menu you can, for example, change the parameters that were set during
the initial installation process. The code 124 must be entered to access the service menu.
The following sub-menus are available:
Bath time limit – Enter desired running time.
Temp. limit – Enter maximum temperature limit. (Default values are 110°C for sauna
bathing and 55°C for steam baths.)
Temp
scale
Di l t t i C l i F h h it
English
Temp
.
scale
–
Di
sp
l
ay
t
empera
t
ure
i
n
C
e
l
s
i
us or
F
a
h
ren
h
e
it
.
Time format – Display time according to the 24-hour or 12-hour clock.
Light switch – Constant (Default On/Off)
Momentary (For trafo with integrated push-button control of light)
Clean up (steam only) – Clean up time (Time between reminders for cleaning)
Run time (Steam generator operation time)
Bath time
priority
(Combi
Compact
only
)
Bath
time
priority
(Combi
Compact
only
)
Select the desired priority for the heater:
Auto – Priority determined according to the temperature set (default setting).
Temperature – Heating up sauna is prioritised.
Humidity – Production of steam is prioritised.
External switch function (Not Combi Compact)
On/Off (Follows Bath time limit. System on or off for each button press)
Extend bath time (Follows Bath time limit. Renewal the bath time without closing the
system. NOTE! Long press more than 3 sek. closes the system (applies also h1)).
Factory reset – All previously set parameters are cancelled and an initial start-up is required.
See “Initial set-up process” on page 14. You must enter code 421 to do this.
Test – Used by Tylö engineers for functional testing and trouble-shooting.
Cleaning - Clean the glass with a proprietary window/glass cleaner and a soft cloth.
17