Tylo H1 - Automatic Key-Lock; Language; Locking the Panel; Settings Menu

Settings menu
Under the Settings menu are a number of extra functions. These are designed to make
troubleshooting easier and can be used to set certain parameters. It is also possible to use
this menu to reset the h1 panel to the factory default setting. There are the following sub-
menus:
menus:
Time – Sets clock
Language – Changes language setting
Display – Sets brightness of display and delay before illumination switches off
Automatic Key-Lock – On/Off and Time before Key-Lock activated
Service – Other parameter settings
Vibration – Sets button vibration
English
Locking the panel
To prevent any unauthorised changes to programmed values, the control panel’s keypad
can be locked by simultaneously pressing the Home (11) and Back (10) buttons for
approximately 2 seconds. A key icon will appear in the status display. To unlock the
keypad, press the Home and Back buttons once again for approximately 2 seconds. The
lighting works even if the panel is locked.
Status
Sh ti d t t i th i th b i (fi 6) h
Sh
ows
ti
me an
d
t
empera
t
ure
i
n
th
e same way as
i
n
th
e
b
as
i
c menu
(fi
gure
6)
even w
h
en
the heater is switched off.
Set time
Enter the correct time by using the arrow keys (6, 9) to adjust the figures up and down.
Confirm with OK.
Language
Select the desired language by using the arrow keys. Confirm with OK.
Display
Sleep – Enter the length of time (in seconds) the control panel remains inactive before the
display switches off.
Automatic key-lock – Enter whether or not the automatic key-lock is to be
activated (current status is displayed) and the length of time before the key-lock is
activated.
16