Ceiling (Box 1):
• Lift the ceiling up and place it carefully on the four (4) panels as shown below.
• Note: Ensure that the electrical connections are placed through the ceiling and are not disconnected
when you put the ceiling into position slowly.
• Tip: To make it easier to pull cables through the ceiling slot, you can take small styropor blocks and
put them on several places between the ceiling and the panels so that the ceiling stays put. When the
cables have been pulled through, remove the styropor blocks and lower the ceiling onto the panels.
• Using a step ladder, open the flaps in the ceiling and turn the wooden support 90º. This fixes the
ceiling securely onto the panels and ensures that the door panel cannot fall out.
Connection between the ceiling and the front wall panel:
• Lift the door on the top of the ceiling.
You will see four connections.
Note: Connect white to black on the two black and white cables.
• Connect the other 2 connections matching the colours.
• Numbered 5, 6, 7 & 8. Connect numbers 5–8 to 5–8.
• Close the front ceiling flap.
A dipole radio antenna is supplied with your infrared sauna for better
FM reception.
You will find the dipole antenna in the bag in the installation manual.
1. Take the dipole antenna (black wires) out of the bag in the
installation manual.
2. Open the cover on the top of the ceiling above the touch screen.
3. Connect the dipole antenna to the wire marked 7
4. Spread the wire out and pull it apart to improve FM radio reception.
Ceiling to the rear panel: (2) connections:
Lift the door panel on the top left of the rear external face
of the ceiling. You will see 4 connections labelled 1–4.
Connect the ceiling connections 1–4 to connections
1–4 on the rear panel.
Ensure that the connections are firmly connected.
After connection close the back access panel.
Page 8
To Next Page
Loading...
