16. This unit should be properly grounded for your safety. The power cord is equipped with
a three-prong plug mated with standard three-prong wall outlets to minimize the
possibility of electric shock.
17. Plug your appliance into a dedicated, properly installed, and grounded wall outlet. Do
not, under any circumstance power and /or grounding should be directed toward a
certified electrician.
18. The foaming materials inside are combustible which must be kept away from fire.
19. It’s forbidden to pull the cable to unplug the plug, pull the plug is a must.
IMPORTANCE: To avoid hazards due to instability,the unit must be placed on an even and
flat surface.
WARNING: This appliance must be grounded.
1) The fuse on the PCB is 15A,if change,must be operated by a technician.
2) voltage fluctuation can’t be exceeded ±10% than the rated voltage,or a
Voltage stabilizer is needed.
IMPORTANCE:To avoid hazards due toinstability, the unit must be placed on an even and
flat surface.
OPERATING PROCEDURES
UNPACKING YOUR ICE MAKER
1. Remove all exterior and interior packaging materials. Check whether all the below
accessories are included or not. If any parts are missing, please contact our customer
service. After you unpack the machine, we recommend you to leaving it for 24 hours
before turning it on.
2. Clean the interior with lukewarm water and a soft cloth or clean the unit using the Self-
Clean function.
3. Find a location for your ice maker where it’s protected from direct sunlight and other
sources of heat (i.e. stove, furnace, radiator). Place the ice maker on a level surface.
Make sure that there is at least 5 inches of space between the back and sides of your
ice maker and the wall.
4. Allow one hour for the refrigerant to settle before plugging the unit for initial use.
5. The appliance must be positioned where the plug is accessible.
To Next Page
Loading...