Notes:
(1)
If you change the countdown time during the middle of the ice making procedure, it will
take effect at the next loop. You can long press the “HOT” button during the ice
making to unload the ice cubes ahead of time.
(2)
The surrounding environmental temperature will influence the time needed for ice
making.
CLEANING & MAINTENANCE
Please thoroughly clean your ice maker before initial use.
Exterior: the outside of the ice maker should be cleaned regularly with a mild detergent and
warm water. Always use a soft cloth to avoid scratching or damaging the housing.
INTERIOR: please use the following Self-Clean function:
1. Add water and vinegar or lemon juice mix (1:1 ratio)
2. Plug in unit,press and hold the CLEAN button for approximately 3 seconds,then
release.The unit will automatically enter Self-clean program. This process takes about
5-6 minutes.When the Self-Clean program is finished,unit will automatically power off.
3. The fan blade will be rotating.This process rinses the inside parts several times.
4. After the Self-Clean program is completed,unplug the power cord and drain out the
water by unplugging the drain cap on the side.Replace drain cap.
5. Add fresh water to the water reservoir,up to the water level mark.
6. Plug the unit and repeat the Self-Clean process by repeating steps 3 to 5. This will
rinse out the vinegar/lemon residue.
7. After draining the water,replace and tighten drain cap.
8. Dry the interior and exterior with a clean,soft cloth.
NOTE: It is strongly recommended to clean the unit before initial use or after the unit has
not been in use for a long period of time.
NOTE
As the production of ice cubes increases, the plastic panel inside the machine (shown
above) might be pressed down by the ice cubes. When the plastic panel is pressed down,
the machine will stop producing ice cubes automatically and the “stoppage” indicator will
light on. Please clean out the ice cubes regularly for continuation of ice making.
To Next Page
Loading...