■ Operation
For correct electronic lift use, follow the indications noted below.
– When the engine is started, indicator will illuminate ②
②②
② (Troubleshooting indicator), showing that the
lift internal controls are deactivated for safety reasons. The external controls on the rear mudguards
remain active.
– Set the upper lift limit with knob ③
③③
③ and move the lift control lever ①
①①
① to the lifting position (A) to
■ Transit safety lock
To activate the transit safety function, proceed as follows:
– Before activating the function, raise the implement by shifting lever ①
①①
① to the raising position (A)
– Turn the arm descent speed adjustment knob ④
④④
④ fully counterclockwise and lock in the raising position.
– Block the lever in the raising position by pushing the locking push button ⑥
⑥⑥
⑥ forwards
Caution
If lever is already in lifting position (A), it must be moved to the neutral position
(central STOP position) and then to the lifting position (A).
■ Swing damping
– To activate the device, move lever ①
①①
① to raising position (A), and press switch ⑧
⑧⑧
⑧. Indicator ⑨
⑨⑨
⑨ lights
up to show that the function is activated.
To Next Page
