TYM T1003 - Page 50

■ Lift use
The lift can be used in three different ways
– Position control
– Draft control
– Float mode
■ Draft control
–
Turn the position/draft mix knob
④
④④
④
fully counterclockwise. Move lever
①
①①
①
to the lowering position
(A)
49
–
Turn the position/draft mix knob
fully counterclockwise. Move lever
to the lowering position
(A)
and adjust to the required working depth using knob ②
②②
②, turning counterclockwise to lower or clockwise
to raise.
– Use lever ①
①①
① to raise and lower the implement at each headland, or when necessary, without using
the adjusting knob.With the implement in the ground, if there is an excessive variation in the working
depth, this variation can be reduced by gradually turning the draft control knob ④
④④
④ clockwise.
Indicator ②
②②
② will switch off and indicator ⑤
⑤⑤
⑤ will illuminate.
■ Position control
– Turn the position/draft mix knob ④
④④
④ fully clockwise
– Lower the implement using lever ①
①①
① and adjust the descent speed using knob ③
③③
③ then set the required
working depth by means of knob ⑧
⑧⑧
⑧.
■ Floating mode
– In order to use the lift in the float function, no swinging restrictions on the full travel of the arms,
turn the knob ⑧
⑧⑧
⑧ fully counterclockwise.