■ Changing Oil in the Front axle
1. Drain the oil from the center diff plug and the drain plug
in each drive.
2. Replace and tighten all drain plugs.
3.Remove the top plug(Vent plug)from each final drive to vent
air from final drives.
4. Remove the dip stick from the filter hole and fill with
17.5ℓ (4.62 US gal) and allow time for the oil to drain into
the final drives.
5. Check the oil level with the dipstick and replace the vent plugs
on both final drives and tighten
75
Important
Always use the same grade and specified oil as replacements
Dispose off the old oil as per local regulations.
Refill the transmission to the correct level on the dipstick with new oil :qty 75ℓ (19.8 US gal).
Some operators have found that when they fill with the correct amount of oil and
dip it, the oil level on the dipstick is too high due to the fact that it takes a while for
the oil to run into the final drives.
Opening the Vent plugs helps to speed this up.
Important
To Next Page
Loading...
