5. STARTING OFF, SHIFTING AND DRIVING
STARTING OFF
① Lift an implement.
② Place the main shift lever, range
shift lever and shuttle shift lever
into the desired positions.
③ Depress the bra k e p e d a l to
release the parking brake.
►
The driving speed in the reverse
direction is almost the same to
the speed in the forward direc-
tion. Make sure to check the
surroundings carefully when
driving backward.
Especially, never drive back-
wards with the range shift lever
in the position H. The driving
speed becomes faster and it
can cause an accident.
•
•
WARNING
6. STOPPING AND PARKING
①
Operate the throttle lever to set
the engine at a low speed.
②
Release the forward driving (HST
type) and accelerator (mechani-
cal) pedals slowly. Depress the
brake pedals for abrupt braking.
③
When the vehicle is completely
stopped, set the shift lever in the
neutral position.
④
Apply the parking brake.
⑤
If an implement is attached to the
vehicle, lower it.
T19O302A
Make sure to keep the following in-
structions for the initial 50-hour use.
(1) Avoid abrupt starting and abrupt
stopping.
(2) Do not use excessive speed or
load.
(3) Drive the tractor only when the
engine is sufciently warm.
(4) Do not idle the engine at the
maximum speed.
(5) Check each part and change oil
and uid after 50-hour use.
(6) Refer to the section Maintenance
for adding and changing engine
oil.
4. RUNNING-IN PERIOD
To Next Page
Loading...
