13.Remove the 4WD shaft couplers by removing
snap ring and sliding couplers onto shaft until
clear of stub shaft
14.Remove the brake linkage, and remove brake
rods from tractor
15.Remove hydraulic pressure tube clamp
Magnetic cruise
4-19
Front 4WD shaft Rear
Tube
Brake linkage
17.Remove a magnetic cruise next to hydrostatic
control pedal.
12.Disconnect the input drive shaft and couplers by removing snap ring and sliding couplers onto
engine until clear of stub shaft.
③
②
⑤①
④
16.Disconnect the linkage from hydrostatic
control system
To Next Page
Loading...
