5-24
3.3 REASSEMBLY
Reassemble the parts in reverse order of disassembly,following these instructions.
Note:
-Each part should be washed clean before reassembly.
-Apply multi-purpose,quality grease to needle bearings in advance.
-Each bolt and nuts should be tightened to the respective specified torque in accordance with
the tightening torque table.
-Every time a gear installed,its smooth rotation should be checked.
-Every snap ring should be seated securely in its groove.
-As each synchromesh assembly maintains a specified width,be sure not to mix different pairs
of the synchro-hub comp.and the synchro-cup.
-Remember to install the snap rings.
(1) Installation of main change gears
Fig.5-46
To Next Page
Loading...
