3 - 10
■ THE PTO MONITOR LAMP on
the dash panel indicates the state of the
PTO shaft.
1. If the monitor glows: The PTO is rotating
2. If the monitor is off: The PTO is off
3. If the monitor blinks: The PTO is pres-
ently stationary but will instantly start
rotating of he clutch pedal is released or
the implements lowered.
Two switches operate the independent PTO.
1. PTO ON/OFF SWITCH: PTO ON/
OFF switch is located on the LHS. on
thesteering column and can be identied
easily with its built in red colored indicator.
When the switch is pushed down to start
the PTO indicator glows to indicate that the
switch and the PTO are in ON position, If
the switch is pushed down again the indica-
tor goes off signaling that the PTO is OFF.
2. PTO CONTROL SWITCH: This
switch is located near the starting key loca-
tion on the dash panel. There are three posi-
tions marked for this switch.
■ OFF at the center
■ MANUAL at the left
■ AUTO AT THE RIGHT.
The PTO shaft will not rotate if either of the
two switches is in OFF position.
The following table explains how the PTO
operates at the two different (Manual & Auto)
positions of the PTO control switch with the
PTO ON/OFF switch in the on position.
To Next Page
