3 - 35
DRVING ON SLOPE
▶ STARTING OFF ON STEEP
① Depress the brake pedals.
② Place range shift lever in the low speed
position.
③ Set the engine at the mid speed with the
throttle lever.
④ Depress the HST pedal fully.
⑤ Release the brake pedal at the same time.
⑥ Pull the throttle lever again to revup the
engine.
▶ TIPS FOR DRIVING ON SLOPE
(1) Set the range shift lever in the low speed
position on a slope to prevent the engine
from stopping.
(2) Keep the driving speed low on a downhill
road.
(3) Do not set the range shift lever in the neu-
tral position on a downhill road.
● On a downhill road, but
use the engine brake. Oth-
erwise, it can cause an ac-
cident.
Warning
▶
CAUTIONS FOR DRIVING
INTO/ OUT OF FIELD
(1) Check that the left and right brake pedals
are connected.
(2) It is dangerous to drive into/out of a eld if
the eld is deep from its bank.Use ramps.
(3) Move in the perpendicular direction to the
bank.
(4) When driving out of the eld, lower the
implement so that the front wheels cannot
be lifted.
(5) It is recommended to drive into a eld
backward to utilize full power.
● Be careful to keep the
tractor's balance when
working on a slope. The
tractor may become out
of balance and roll over.
● It is very dangerous to
ride a person as a front
weight.
Warning
To Next Page
Loading...
