Table 7: LEDs
2.3.7 Battery
The integrated batteries in the PABLO® Sensors can be charged via the PABLO® Charger
included in the scope of supply. Because this charging unit has been tested as a medical
device, the Pablo® Sensors are also electrically safe during a charging process. Follow
the instructions, however, about the use of the device during a charging process.
The use of charging units that have not been recommended by
TYROMOTION GmbH is expressly forbidden, because unforeseen risks
could arise for people and equipment.
Charging Battery:
In order to charge the batteries, first connect the PABLO® Charger to a plug and then
put the PABLO® Sensors onto the charging sockets destined for the sensors. The PABLO®
Sensors switches into the charging mode automatically (Note the LED display described
in Chapter 2.3.6).
PABLO® Handsensor und PABLO® Motionsensor must be fully charged before being used
for the first time
To Next Page
