EN – 48
FAQ-Frequently Asked-Questions
Why does the PABLO® Sensor not connect to my PC?
Make sure your Bluetooth adaptor is connected to your PC and you have started the
tyroS® Software. In case you have trouble installing the Bluetooth adaptor, ask your
system administrator for help and read the Installation Guide in chapter 3.
Also make sure the PABLO® Sensor battery is charged. Check the LED display on the
PABLO® Sensor (chapter 2.3.6).
How long can I use a charged PABLO® Sensor for therapy?
In use, the battery service life is approximately 8 hours (when fully charged); thereafter
the battery will have to be charged again.
Which motions can be monitored with the PABLO® system?
When using the PABLO® System, certain aspects have to be considered in order to
achieve correct values.
The PABLO® Sensor has to be fixated or attached to the patient’s body in such a way that
it can tilt or rotate during therapy as depicted in Figure 36 and Figure 37.
To Next Page
