EasyManuals Logo

U-Line 3000 SERIES Use And Care Guide

U-Line 3000 SERIES
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
U-Line 3000 Series Maintenance 11
Leveling
IMPORTANTIMPORTANT
Unit must be level for proper door operation
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side
edge as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise
or lower each corner of the unit (2) as necessary.
3. To rotate rear leveler legs remove grille (See Removing and
Installing Grille on page
11
)
4. Using the provided 1/4” T bar allen wrench rotate the 2
adjustment screws as shown below.
5. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
Removing and Installing Grille
WARNING
Disconnect electrical power to the unit before
removing the grille.
Edges of sheet metal may be sharp
Removing the grille.
1. Disconnect power to unit.
2. Using the included 7/64” Allen wrench, loosen both grille locking
screws. See below
3. Gently pull grille away from unit until it stop.
4. Push Grill tabs towards the center of the unit to lift rails off
locking screw.
5. Pull grille free from unit.
Installing the grille.
1. Align slots in grille rail with screw heads in base of unit
2. Push grille tabs towards the center of the unit and set tabs over
screw head.
3. Slide grille into position. Using included 7/64 Allen wrench
tighten grille locking screws.
Adjusting Grille
The grille has an automatic vertical plane adjustment and can also
be adjusted on its horizontal plane as well. To adjust your grille to
match your surrounding cabinetry follow the instructions below.
1. Loosen the locking bolts on the inside of the grille tabs.
Locking bolts are located on the inside of each grille rail.
2. Pull grille out to desired position and secure locking bolts.
3. The grille has a skirt that will self adjust to the height of your
floor.
6 3000 Series Maintenance
1
2
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Rotate Clockwise to raise rear leg
Rotate Counter-Clockwise to lower
Grille Mounting
Screws
Self Adjusting Grille
Skirt

Other manuals for U-Line 3000 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the U-Line 3000 SERIES and is the answer not in the manual?

U-Line 3000 SERIES Specifications

General IconGeneral
BrandU-Line
Model3000 SERIES
CategoryRefrigerator
LanguageEnglish

Related product manuals