USER GUIDE
Cleaning
u-line.com
Under normal conditions cleaning should be
done when the display shows
CL. You may
initiate a cleaning cycle at any time by pressing
and holding the clean button for 10 seconds.
0 1
will appear in the display indicating the start of
the cleaning process.
You may override
CL in the display without cleaning by
pressing and holding the up, down, & light button for 10
seconds.
ICE will scroll in the display and the cleaning
reminder
(CL) will be reset for another approximate six
month cycle. Failure to clean may reduce the quality and
quantity of ice produced. Once the clean cycle begins, it
can be canceled by pressing three times. Press once
more to start making ice. The clean cycle will
automatically cancel if user fails to activate control at
steps 2, 3b, and 5b within 2 hours.
Required for cleaning:
Hose and funnel – provided with unit
Bucket and cleaning sponge
Clean water
SafeCLEAN Plus™ Cleaner (Part No. 80-55266-00)
– included with unit
Need more cleaner? Visit u-line.com.
Use only SafeCLEAN Plus
TM
Cleaner. Use of any
other cleaner may damage the finish of the
evaporator and will void the warranty.
Follow safety and handling instructions printed
on the SafeCLEAN Plus
TM
bottle.
NOTICE:
For 3 Class models only
: the water filter must
remain in place during the cleaning process.
Cleaning Process (approximate time: 40 minutes)
1. Press and Hold for 10 seconds
a. 0 1 will appear in the display
b. Remove access shield
c. Remove all ice in bin
d. Remove any ice protruding from the ice dispenser
tube
e. Insert the end of the cleaning tube into the ice
dispenser; slowly pour in approximately 1 quart of
hot water. This will melt ice inside the dispenser
tube. It is normal for some water to flow out of
the ice dispenser tube and exit from the vent tube
while pouring. Omit this step if no ice is in the ice
dispenser tube.
2. Press and release
a.
02 will appear in the display
b. Mix 4 ounces of SafeCLEAN Plus™ with 2 quarts of
water
3. Wait until
03 appears in the display
a. Using the funnel and cleaning tube, slowly pour
3
/
4
of the cleaning solution into the dispenser
tube. Air and some water will exit the vent tube.
Remove cleaning tube.
b. Press and release
Ice
Dispenser
Tube
Vent Tube
31
To Next Page
Loading...
Need help?
General