U-Line ICE-MAKER - User Manual

Questions and Answers

M
Matthew GreenAug 17, 2025
Why is my U-Line ICE-MAKER Ice Maker not cold enough?
- E
  ebarronAug 17, 2025
  If your U-Line Ice Maker isn't cold enough, several factors could be at play. Ensure the door gasket is sealing properly, and adjust the door if needed. Check for any items obstructing the door and reposition or remove them. Clean the condenser coils, and make sure airflow to the front grille isn't blocked. If the temperature isn't set cold enough, turn the control knob clockwise and allow 24 hours for stabilization. Lastly, if the evaporator is frosted, turn off the unit to manually defrost it.
E
erinhernandezAug 20, 2025
What to do if my U-Line ICE-MAKER is not making ice?
- M
  Michael JensenAug 20, 2025
  If your U-Line Ice Maker is not producing ice, make sure that the bin arm isn't locked in the upright position; if it is, lower it. Also, check that the unit is receiving water. If not, turn on the water supply or contact a plumber.
K
Kevin BennettAug 22, 2025
Why is my U-Line ICE-MAKER not making enough ice?
- V
  Vanessa LandryAug 23, 2025
  If your U-Line Ice Maker isn't making enough ice, try adjusting the control to a warmer setting by turning it counterclockwise. Also, if the ice cube size is too large, set it to a smaller size. Dirty condenser coils can also be a factor; clean them to resolve the issue.
M
Mary ReyesAug 25, 2025
Why is water leaking out the back of my U-Line ICE-MAKER?
- R
  Robin ThompsonAug 26, 2025
  If you notice water leaking from the back of your U-Line Ice Maker, the water supply connection may be leaking. Try tightening the fitting to resolve the issue.
A
anitajonesAug 27, 2025
Why is water leaking into the ice bucket of my U-Line Ice Maker?
- C
  Christian KingAug 27, 2025
  If water is leaking into the ice bucket of your U-Line Ice Maker, the water level might be set too high. Try setting the cube size smaller.
R
Rachel JohnsonAug 30, 2025
Why is my U-Line ICE-MAKER Ice Maker frosting up?
- J
  John SmithAug 30, 2025
  If your U-Line Ice Maker is frosting up, and it is a manual defrost model (SP18, 95, 98, Combo 29A, or 75A), consult the defrosting instructions. Also, check if the door gasket is sealing properly and adjust the door if needed. High ambient temperatures or humidity can also cause frosting; in this case, manually defrost the unit.
A
adriennehannaSep 1, 2025
What to do if the fresh food section on my U-Line Combo unit is too cold?
- S
  Spencer HowellSep 1, 2025
  If your U-Line Combo unit's fresh food section is too cold, ensure the ice bucket is fully inserted. Also, make sure the flap door is closed correctly.
G
Gabriel OwenSep 4, 2025
How to adjust the temperature if my U-Line Ice Maker is too cold?
- J
  Juan HaynesSep 4, 2025
  If your U-Line Ice Maker is too cold, the temperature control might be set too low. Adjust the control to a warmer setting by turning it counterclockwise.
C
Charles StewartSep 7, 2025
Why are the ice cubes sticking together in my U-Line ICE-MAKER?
- M
  Mr. Timothy LiSep 7, 2025
  If your U-Line Ice Maker's ice cubes are sticking together, it could be due to the door gasket not sealing properly. Adjust the door to ensure a proper seal. Infrequent use of the cubes can also cause them to stick; in this case, simply break them apart.
M
marisa72Sep 9, 2025
Why is my U-Line ICE-MAKER Ice Maker making noise during operation?
- R
  Randall PriceSep 9, 2025
  If you hear unusual noises during the operation of your U-Line Ice Maker, it could be that the copper water supply tubing is contacting internal components. Carefully bend the tubing away from the cabinet and components. Alternatively, a fan blade might be touching an obstruction like wiring or foam insulation; if so, remove the obstruction.

Summary

U-Line Corporation Limited Warranty

Product Introduction and Information

Introduction to U-Line Products

Overview of U-Line's pioneering role, innovation, and global market presence.

Recording Model and Serial Number

Instructions for recording unit's model and serial number for service and registration.

Safety Guidelines and Precautions

Understanding Safety Alert Symbols

Defines hazard symbols: Danger, Warning, Caution, and Important for user safety.

General Safety Precautions

Covers critical safety warnings for installation, operation, and child safety.

Installation and Setup

Site Preparation Guidelines

Instructions for preparing the installation site, including level surface and temperature.

Electrical Connection and Safety

Emphasizes proper grounding and avoiding extension cords for electrical connection.

Unit Positioning and Airflow Requirements

Instructions on positioning the unit for proper airflow and door clearance.

Leveling the Unit

Steps for ensuring the unit is level using adjustable feet for optimal performance.

Connecting Water Supply for Ice Makers

Detailed instructions for connecting the cold water supply line to ice maker models.

Grille Installation Procedure

Steps for removing and reinstalling the front grille, including control knob removal.

Glass Shelf Installation Guide

Instructions for correctly installing glass shelves into the unit.

Built-in Installation Requirements

Requirements and clearances for integrating the unit into cabinetry.

Custom Door Panel Insert Installation

Guidelines for installing a custom panel on the unit door, including weight limits.

Finishing Wine Rack Wood Trim

Instructions for finishing or staining the wood trim on wine racks for the 75 BEV model.

Wine Rack Removal and Installation

Procedures for removing and reinserting wine racks for cleaning or refinishing.

Reversing the Unit Door

Detailed steps for changing the door swing direction for various models.

Reversing Stainless Steel Doors

Specific instructions for reversing doors on stainless steel U-Line models.

Door Alignment Procedure

Methods to ensure proper door alignment and gasket seal.

75 BEV Wine Rack Usage

Information on using and maintaining wine racks in the 75 BEV model.

Operation and Maintenance Guide

Initial Start-up and Temperature Adjustment

Steps for initial unit setup, including running overnight and adjusting temperature.

Temperature Control Settings

How to adjust the temperature setting for different U-Line models.

Normal Unit Operation and Sounds

Explains typical unit operation, sounds, and ice production for various models.

Marine Use Considerations

Special instructions for operating U-Line units in a marine environment.

Adjusting Ice Cube Size

Procedure for modifying the size of ice cubes produced by the ice maker.

Interior Lighting System

Details on the interior lighting system and its operation.

Light Bulb Replacement Instructions

Step-by-step guide for safely replacing the interior light bulb.

Proper Storage and Wine Rack Stocking

Advice on how to store bottles and stock wine racks for optimal presentation.

Optimal Wine Storage Temperatures

Recommended storage temperatures for wine in the 75 BEV unit.

Cleaning and Maintenance Procedures

Guidelines for cleaning the exterior and interior of the unit.

Condenser Cleaning Frequency

Instructions for cleaning the condenser coil every three months for efficient operation.

Defrosting Manual and Automatic Models

How to defrost manual defrost models and information on automatic defrost.

Unit Storage for Extended Periods

Steps to take when storing the unit for long-term non-use.

Troubleshooting and Service Information

Troubleshooting Common Issues

A guide to identify and resolve common problems with the unit.

Service Contact and Model Information

Instructions on how to contact U-Line for service and find model information.

Genuine Replacement Parts

Guidance on using only genuine U-Line replacement parts for optimal performance.

Product Specifications Overview

Technical details and capacities for various U-Line models.

U-Line ICE-MAKER Specifications

General

Ice Shape	Crescent
Power Source	Electric
Voltage	115 V
Installation Type	Freestanding or Built-In
Finish	Stainless steel
Control Type	Digital
Water Supply	Direct Water Line Connection
Material	Stainless Steel
Warranty	1 year parts and labor