34
User’s Manual
INITIAL START-UP AND ADJUSTING
THE TEMPERATURE CONTROL
U-Line recommends the unit be allowed to run overnight
and make ice on ice-maker models prior to loading with
product.
It is possible that dirt or scale will dislodge in the water line.
Always throw away all ice cubes made during the first two
to three hours of operation.
Once the installation is complete, the unit is ready for initial start-up and
operation.
NOTE
BI-95 and BI-98 models have the ON-OFF switch behind the
front grille. A small opening in the top of the grille is pro-
vided to access the switch (Figure 36).
Some models may also turn off when the temperature control is turned
all the way toward warmer until it stops (clicks).
Figure 36
1. Wipe out inside of unit, again, with a clean, water-dampened cloth.
2. Plug the appliance cord into a 115V polarized, grounded electrical
outlet.
3. Check that the ON-OFF switch in the ON position. (All units are
shipped in the ON position.)
OFF
ON
UL127A
30035 User Manual Body.qxd 1/5/05 8:08 AM Page 34
To Next Page
Loading...
Need help?
General
