PAGE 7 OF 30 0318 IH-7259
PREVENTATIVE MAINTENANCE
Monthly
• Blow off all dust and debris from machine.
• Check for any unusual wear on components.
• Check for any unusual wear or buildup on the side
of the seal assembly.
REPLACING THE EDGE SEAL
Materials required:
• H-7287 Edge Sealer
NOTE: The system must be on for the following
procedure. Ensure components are cool
before proceeding.
1. Lower the clamp handle to open edge seal.
2. Unthread the edge seal by twisting counter-clockwise.
(See Figures 17 and 18)
3. Pull the edge seal wheel away from black plastic
gear. (See Figure 18)
4. Install the new edge seal:
• Align the three connection pins on new wheel with
the three receptacle holes in seat.
NOTE: The hole pattern and pins are in a keyed
pattern.
• By hand, thread the edge seal clockwise until tight.
• Do not load film. Raise the clamp handle to close
the edge seal.
5. Press reset key (//), then, start key to calibrate the
new edge seal. Load film.
MAINTENANCE AND REPAIR
Figure 16 Fig ure 17
Figure 18
Receptacle
Holes (3)
Edge Seal
Wheel
Clamp Handle
(Shown Open)
Edge Seal
Wheel
Black Plastic
Gear
To Next Page
Loading...