V.
Operating the Machine
Steps:
1.Turn on the Power. You will hear two clicking sounds.
2.Press MIX1/Set1 and MIX2/Set2 to start the mixers.
3.Press FREEZE, the Light above FREEZE will flash for 5 minutes, then the compressor
will start working.
If you want to change the consistency level, please follow the steps below:
Method 1:
a. Press Set3 for 3 seconds, release, the lights above MIX1 and MIX2 will flash.
b.
Press MIX1/Set1 to change the consistency in Tank 1, and MIX2/Set2 to change
the consistency in in Tank 2.
Method 2:
a.
Press MIX1/Set1 or MIX2/Set2 for 3 seconds, release, lights above MIX1/Set1 or
MIX2/Set2 will flash.
b.
Press MIX1/Set1 to change the consistency in Tank 1, and/or MIX2/Set2 to
change the
consistency in Tank 2.
NOTE: If the consistency level is on level 0, compressor and mixer will continue
working, but the corresponding tank will not freeze.
It usually takes one hour for the slush to show up in the tank. Please be patient.
To Next Page
Loading...