U-tec Ultraloq UL3 Series Installation Instructions

- 11 -
Installing Handles
1. Press lever handles onto handle posts.
2. Test the mechanical operation of the lock by rotating
handle from inside. The movement of the bolt should be
smooth and unobstructed. If the operation is not smooth,
review the previous steps to ensure proper installation.
If the handles are installed in the wrong direction, you
need to remove them and re-install.
To remove the handle, you need to insert the screwdriver
into the hole in the handle, push in and hold. Then pull the
lever handle out.
Handle plug position
The handle is not fully plugged in.The handle is plugged in correctly.
or
98

U-tec Ultraloq UL3 Series Specifications

General

Brand	U-tec
Model	Ultraloq UL3 Series
Category	Door locks
Language	English