28 29
Step 14: Rim Lock
The wheels include a rim lock, which helps keep
the tyre securely on the rim.
Check the tension on the M8 nut installed on the
threaded bolt on the inside face of the rim, directly
opposite the tyre valve. It should be tight against
the rim.
Do not over-tighten the rim lock, as this can cause
distortion to the rim.
b.
a.
Step 13:
Rear Motor:
Repeat Step 12b to connect rear motor cables.
Step 15: Steering Alignment
a. Locate the side bolts that hold the handlebars
on the stem. Loosen them enough to allow the
handlebars to rotate without turning the wheel.
b. Sitting on the bike, align the handlebars so
they are perpendicular to the wheel. Once the
handlebars are aligned, tighten the two bolts
slowly, alternating between the left side and
the right side; tighten to the setting specified
on the headset.
Note: Tightening the bolt on one side fully before
tightening the other side can damage the threads
and put strain on the bolts.
Proper alignment:
To Next Page
Loading...
Need help?
General
