Need help?Do you have a question about the Ubiquiti airFiber AF 60 and is the answer not in the manual?
General| Frequency Band | 60 GHz |
|---|---|
| Antenna Gain | 43 dBi |
| Operating Humidity | 5 to 95% non-condensing |
| Certifications | FCC, IC, CE |
| IP Rating | IP67 |
| Power Supply | PoE (Power over Ethernet) |
| Processor Specs | Dual-core processor |
| Memory | 512 MB RAM |
| Networking Interface | 1 x Gigabit Ethernet |
| Operating Temperature | -40°C to 55°C |
| Mounting | Pole mount or wall mount |
Enable Access Point mode and set a common SSID for both radios.
Process of aiming the AP and Station to establish a wireless link.
Visual aiming of the AP and Station, adjusting azimuth and elevation for optimal signal.
Using the configuration interface's Align Antenna tool for fine-tuning.
Tightening nuts to lock the alignment, ensuring signal constancy during the process.
Adherence to voltage, frequency, current, and service requirements. Use of provided power cord.
Importance of grounding wire, protective earthing, and bonding in accordance with local regulations.
To Next Page