Need help?Do you have a question about the Ubiquiti BulletAC-IP67 and is the answer not in the manual?
General| Model | BulletAC-IP67 |
|---|---|
| Category | Wireless Access Point |
| Wireless Standards | 802.11 a/b/g/n/ac |
| Frequency Bands | 2.4 GHz and 5 GHz |
| Ethernet Port | 1 x 10/100/1000 Mbps |
| Ingress Protection | IP67 |
| Wireless Approvals | FCC, IC, CE |
| ESD/EMP Protection | ± 24 kV Contact / Air |
| Shock and Vibration | ETSI300-019-1.4 |
| Antenna Connector | RP-SMA |
| Max Data Rate | 867 Mbps (5 GHz), 300 Mbps (2.4 GHz) |
| Power Method | 24V Passive PoE |
| Mounting | Pole or wall mount |
| Processor Specs | MIPS 74Kc |
| Operating Humidity | 5 to 95% non-condensing |
| Operating Temperature | -40 to 80° C (-40 to 176° F) |
Specifies using shielded Category 5 cabling with drain wire for outdoor Ethernet connections.
Recommends using two Ethernet Surge Protectors (ETH-SP) for outdoor installations.
Detailed instructions for disassembling, connecting cables, and assembling the Bullet AC IP67.
Guide to configuring the Bullet AC IP67 using the UNMS mobile application.
Instructions for accessing and configuring the Bullet AC IP67 via a web browser.
Setting up antenna gain and accounting for cable loss for optimal device performance.
Important safety notices regarding water, electrical storms, and proper usage.
Guidance on radiation exposure limits and recommended minimum installation distances.
To Next Page