Ubiquiti ER-X-SFP User Manual

EdgeRouter X SFP Power Adapter (24V, 2.5A) Power Cord
Package Contents
Installation Requirements
For indoor applications, use Category 5 (or above) UTP cabling approved for indoor use.
For outdoor applications, shielded Category 5 (or above) cabling should be used for all
wired Ethernet connections and should be grounded through the AC ground of the power
supply.
We recommend that you protect your networks from harmful outdoor environments and
destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. For
more details, visit:
ui.com/toughcable
Note: Although the cabling can be located outdoors, the EdgeRouter itself should
be housed inside a protective enclosure.
Hardware Overview
ER-X-SFP Quick Start Guide
×
Click for
Table of Contents

Ubiquiti ER-X-SFP Specifications

General

Flash Memory	256 MB NAND
Operating System	EdgeOS
Operating Temperature	-10 to 45° C (14 to 113° F)
Product Type	Router
Ports	5 x 10/100/1000 Ethernet ports, 1 x SFP port
CPU	Dual-Core 880 MHz
RAM	256 MB
Dimensions	142 x 75 x 23 mm (5.59 x 2.95 x 0.91 in)
Operating Humidity	10 to 90% non-condensing
PoE Support	Yes (Passive PoE input on Eth0, Passive PoE output on Eth4)

Summary

Hardware Component Details

LED and Port Indicators

Hardware Installation Procedures

Connecting Power

Connecting Ethernet

Accessing the EdgeOS Configuration Interface

Accessing via DHCP

Steps to access the configuration interface using DHCP.

Accessing via Static IP

Steps to access the configuration interface using a static IP.

Device Configuration and Management

Configuring PoE Settings

Guide to enable or disable 24V passive PoE on ports.

Specifications and Safety

Safety Notices

Safety and Compliance Information

Electrical Safety Information

Guidelines for safe electrical connection and usage.