EasyManuals Logo

uebe Cyclotest 2 plus User Manual

uebe Cyclotest 2 plus
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
EN-38
Safety instructions
EN-39
Safety instructions
Optimum functioning of your cyclotest® 2 plus cannot be guaranteed
if you fail to observe the following safety instructions. Please read
through the entire instructions for use carefully before using the unit.
Follow the described procedure when using the unit on a daily basis.
Check that the sensor is undamaged prior to measurement. De-
pending on where you use the sensor for measurement, a damaged
sensor could cause unintentional injury.
While cyclotest® 2 plus still “knows” too little about you, i.e. has
still not stored a sufcient amount of cycle values, a longer fertile
phase will be displayed for your assurance. The fertile phase prior
to ovulation can be pinpointed more precisely only when at least
six cycles have been stored.
cyclotest® 2 plus has a waking function: Once you have been dis-
creetly woken by the unit, bring the unit into bed with you, place
the sensor under your tongue, press the large Measurement button
and wait until the unit beeps – done. All without having to get out
Using the unit in the immediate vicinity of mobile phones, micro-
wave appliances or other devices with strong electromagnetic elds
may result in impaired functioning. Maintain a minimum distance
of 3 m from such devices when using this unit.
Do not under any circumstances open or modify the unit. This is a
medical product.
Please comply with the specied ambient conditions for measure-
ment. See Technical data, Page 62.
These instructions are intended to help the user to use cyclotest® 2
plus safely and efciently and must be kept with the product and
if necessary passed on.
The unit must be used in accordance with the procedures contained
in these instructions and must not be used for other purposes.
cyclotest® 2 plus is a diagnostic unit for determining the fertile
and infertile days in a woman’s cycle and should not be used as
a substitute for contraception methods (e.g. condom). During the
fertile phase you should, if you do not want to get pregnant, use
the contraception method of your choice.
The simultaneous use of cyclotest® 2 plus and the pill is pointless.
The pill is a contraceptive and renders the use of cyclotest® 2 plus
superuous.
You are advised not to use the unit during irregular work and sleep
periods (e.g. shift work) and in changeable cycles (e.g. puberty,
illness, cycle lengths over 45 days).
It is essential to ensure correct functioning of cyclotest® 2 plus that
you perform the morning measurements of wake-up temperature
before getting up. You should have slept for at least 5 hours and in
the last hour prior to measurement you should not have got up.

Table of Contents

Other manuals for uebe Cyclotest 2 plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the uebe Cyclotest 2 plus and is the answer not in the manual?

uebe Cyclotest 2 plus Specifications

General IconGeneral
Branduebe
ModelCyclotest 2 plus
CategoryTest Equipment
LanguageEnglish