EN-58
Frequently asked questions
EN-59
Frequently asked questions
Fig. no. 26
Wake-up alarm on (more bars)
Again press the large round Measurement button once briey.
Fig. no. 27
Wake-up alarm off (fewer bars)
To turn the wake-up alarm back on, proceed as described above. The
unit conrms the input with a beep.
Fever and high temperature
An atypical increase in temperature is blanked out during the cycle re-
cording. If there are not enough temperature values that can be evalu-
ated during a cycle, the fertile phase is extended. See Fig. no. 11 “H“.
Measurement button pressed without sensor at point
of measurement
cyclotest® 2 plus breaks off the measurement and signals this acousti-
cally with three beeps and optically with an “E”. See Fig. no. 13.
Pregnancy display
cyclotest® 2 plus is waiting for your cycle start. In this case, there are
two possibilities:
1) You have forgotten to start a new cycle on the rst day of
menstruation.
2) If there is no menstruation, you may be pregnant.
Fig. no. 28
Important: If within a cycle you observe inexplicable temperature re-
sponses which deviate from your previous cycles, call the cyclotest®
service hotline.
Irregular cycle
The unit displays a cycle length of 32 days in the bar chart. Counting
is continued automatically for longer cycles.
Fig. no. 29
You can recognise this by the ashing square
in the bar chart, by the small arrow under-
neath and by the digit at top left.
In the event of irregular cycle lengths, a longer fertile phase is
displayed.
To Next Page
Loading...
