To Next PageTo Next Page
Need help?Do you have a question about the UEBERALL UBK-3 and is the answer not in the manual?
UV radiation can harm eyes and skin. Always wear protective glasses and gloves. Never look at a lit UV lamp.
UV lamps, quartz glass, and sensors are fragile. Handle with care and avoid touching glass surfaces with bare hands.
Ensure installation, operation, and maintenance follow the manual. Verify pressure, flow, water quality, and power match specifications.
Component identification for UV reactor and installation into the pipe system per dimensional drawings.
Covers vertical mounting, service height, wall mounting, valve installation, and electrical connections.
Guide for installing the sensor window, sensor cartridge, and connecting the sensor cable.
Instructions for handling, cleaning, and properly inserting the quartz jacket into the reactor.
Step-by-step process for connecting, inserting, and securing the UV lamp within the unit.
Three LEDs on the switch cabinet indicate normal operation, pre-alarm, or main alarm status.
Adjust the potentiometer for correct operation after warm-up, ensuring the green LED indicates status.
The unit requires minimal maintenance; check UV lamp output and clean components as needed.
Yellow alarm for dirt, red alarm for major issues like lamp failure or water quality. Resetting alarms.
Procedure to reset the digital operation hour meter to '0.0 h' after UV lamp replacement.
Systematic table to diagnose faults by matching symptoms to potential causes and solutions.
Continuation of the fault table, covering additional issues like sensor connection, ballast defects, and vibrations.
List of spare parts with part numbers for UBK models, referencing manual drawings and wiring diagrams.
General| Type | Laboratory Shaker |
|---|---|
| Model | UBK-3 |
| Capacity | 3 kg |
| Speed Range | 50-300 rpm |
| Orbit Diameter | 20 mm |
| Timer | 0-120 min |
| Power Supply | 220V/50Hz |
