To Next Page

To Previous Page

INTRODUCTION

The CD100A Combustible Gas Leak Detector is capable of sensing many

combustible, non-combustible and toxic gases that include but are not

limited to the following:

Acetone Industrial Solvents

Alcohol Jet Fuel

Ammonia Lacquer Thinners

Benzene Methane

Butane Naphtha

Ethylene Oxide Natural Gas

Gasoline-Petrol Propane

Halon Refrigerants

Hydrogen Sulfide Toluene

NOTE: This leak detector is factory calibrated for methane in air.

WARNING! This unit should not be used for detection of

Carbon Monoxide.

Features include

• Fully adjustable steady tic rate accelerates as the sensor tip

approaches a leak (the adjustment knob is located on the side of the unit)

• “Tip-Light” in sensor cover used to see around the area of leak in a

dark environment

• Long 18” flexible gooseneck

• Audible and visual leak indicator

• Low battery indicator and separate battery compartment for

easy replacement

• Power On light

• Solid state semiconductor sensor provides instantaneous detection

• Sensor cover to protect sensor

• Ruggedized protective rubber boot

• Socket for optional earphone

Questions and Answers:

Need help?

Do you have a question about the UEi CD100A and is the answer not in the manual?

UEi CD100A Specifications

General