UEi DL479 User Manual (English)

To Next Page

DL479

NCV

°C°F

CAT IV 600V

CAT III 1000V

MAX

µA

CAT Ill

1000V 600A

True RMS

Hz / Duty

MAX/MIN

INSTRUCTION MANUAL

ENGLISH

DL479

AC 600A TRMS HVAC/R

Clamp Meter

CATEGORY DEFINITIONS

Measurement

Category

Short-Circuit

(typical) kA

Location in the

building installation

II < 10 Circuits connected to mains socket

outlets and similar points in the MAINS

installation

III < 50 Mains distributions parts of the building

IV > 50 Source of the mains installation in the

building

WARRANTY

The DL479 is warranted to be free from defects in materials and workmanship

for a period of two years from the date of purchase. If within the warranty

period your instrument should become inoperative from such defects, the unit

will be repaired or replaced at UEi’s option. This warranty covers normal use

and does not cover damage which occurs in shipment or failure which results

from alteration, tampering, accident, misuse, abuse, neglect or improper

maintenance. Batteries and consequential damage resulting from failed

batteries are not covered by warranty.

Any implied warranties, including but not limited to implied warranties of

merchantability and fitness for a particular purpose, are limited to the express

warranty. UEi shall not be liable for loss of use of the instrument or other

incidental or consequential damages, expenses, or economic loss, or for any

claim or claims for such damage, expenses or economic loss.

A purchase receipt or other proof of original purchase date will be required

before warranty repairs will be rendered. Instruments out of warranty will be

repaired (when repairable) for a service charge.

This warranty gives you specific legal rights. You may also have other rights,

which vary from state to state.

DISPOSAL

CAUTION: This symbol indicates that equipment and its accessories

shall be subject to separate collection and correct disposal.

CLEANING

Periodically clean your meter’s case using a damp cloth. DO NOT use abrasive,

ﬂammable liquids, cleaning solvents, or strong detergents as they may damage the

ﬁnish, impair safety, or affect the reliability of the structural components.

STORAGE

Remove the batteries when instrument is not in use for a prolonged period of time.

Do not expose to high temperatures or humidity. After a period of storage in extreme

conditions exceeding the limits mentioned in the General Speciﬁcations section, allow

the instrument to return to normal operating conditions before using it.

1000V

CAT III

600V

CAT IV

99 Washington Street

Melrose, MA 02176

Phone 781-665-1400

Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

Need help?

Do you have a question about the UEi DL479 and is the answer not in the manual?

UEi DL479 Specifications

General

Model	DL479
Manufacturer	UEi
Type	Clamp Meter
Continuity	Yes
Diode Test	Yes
Data Logging	No
PC Interface	No
Auto Ranging	Yes
Data Hold	Yes
Min/Max	Yes
Inrush Current	Yes
Low Impedance (LoZ)	Yes
Non-Contact Voltage Detection (NCV)	Yes
Display	Digital LCD
AC Voltage Range	600V
DC Voltage Range	600V
Temperature Range	-4.0 °F to 1832 °F (-20.0 °C to 1000 °C)
Safety Rating	CAT III 600V