Ugolini ICON

20
ICON
7. 3. 2 DISMANTLING THE
RECOVER
1 Click open the two parts. (see figure 9).
figure 9
2
Remove the left part of the recover and then
the right part. (see figure 10).
figure 10
7. 3. 3 CLEANING
1
Prepare at least two gallons of a mild
cleaning solution of warm (45-60 °C 120-140 °F)
potable water and dishwashing detergent. Do not
use abrasive detergent.
Important: if present, follow label directions, as
too strong a solution can cause parts damage,
while too mild a solution will not provide
adequate cleaning.
2 Using a brush, suitable for the purpose,
thoroughly clean all disassembled parts in the
cleaning solution.
3 In the same manner clean the evaporator
cylinder(s) using a soft bristle brush.
4 Rinse all cleaned parts with cool clean water.
7. 3. 4 SANITIZING
Sanitizing should be performed immediately
prior to starting the machine. Do not allow the
unit to sit for extended periods of time after
sanitization.
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source.
IMPORTANT
Do not attempt to wash any machine
components in a dishwasher.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastic parts.
ATTENTION
When cleaning the machine, dump it, do
not allow excessive amounts of water
around the electrically operated
components of the unit. Electrical shock or
damage to the machine may result.