22
manufacturer. (see figure 29)
figure 29
3 Once weekly: check for the presence of any leakage by
removing the purpose-designed tray (see figure 30). In case
they are present, make sure the scraper coupling seal is
properly installed and not worn. If it is, replace with an original
spare part from the manufacturer (see figure 29).
figure 30
4 Once a month: eliminate any dust that has built up on the
condenser filter situated at the rear of the machine. (see figure
31)
figure 31
5 In the event of strange noises, disconnect the machine and
call for assistance.
6 In the event of a breakdown, disconnect the machine as it
may start again suddenly.
7 After all repair work, reposition every component, such as
the screws and covers, in their original position.
ATTENTION
Be careful with the condenser fins as they are sharp.
To Previous Page
Loading...
Need help?
General
