| User Manual
16
EN
C- INSTALLATION OF YOUR PRODUCT
Electric Connection Rules
The product will start when you insert the plug into the outlet as shown in picture 8.
WARNING!
It is forbidden to insert the plug into multiple socket and to use extension cord (Picture 9).
There is no separate on-o switch on your product.
Do not contact the cables of your product, which are connected to the mains, to hot surfaces.
The outlet you will use must be grounded. Furthermore, the outlet to be used must have the resistance
of at least 10-16 A and be protected with a suitable fuse. Denitely take assistance from our technical
service or a competent electrician with regards to the fuse that should be present on the mains where
the outlet is connected.
Mains voltage and frequency must be same with the value written on the label inside your product.
If your mains voltage is extremely below or above the value indicated, denitely supply demanded
voltage by using a voltage regulator. You can get assistance from an expert electrician with this regard.
Do not place your product's cord onto passageways. This may cause you to get injured and damage
your device (Picture 10).
PICTURE 9
PICTURE 8
PICTURE 10
10-16A
To Next Page
Loading...
