Ugur UDD 1600 D3KL NF - Cleaning, Maintenance, and Transportation; Cleaning Procedures; Product Maintenance

User Manual |
25
EN
E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
PRODUCT
CLEANING
Cleanng of your devce s composed of two stages, whch are the nternal cleanng and external
cleanng.
Following warnings must certainly be abided before start cleaning.
CAUTION!
Unplug your product before every cleaning.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Never use domestic cleaning agents, abrasive and scratching substances (surface cleaners,
detergent, ammable and sparkling, solvent like gasoline, thinner, acid) as cleaning agents.
Otherwise loosening may occur in the plastic parts of your product.
Never use owing and pressurized water for cleaning.
Internal cleaning
Transfer the foodstu inside your product to a convenient place.
Before the internal cleaning, wait until the temperatures of the internal parts of your product reaches
to the ambient temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents rec-
ommended by Soğutma A..
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three (3) hours after running your product as stated in this manual.
External cleaning
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section while cleaning.
Clean the door gasket by using clean soapy water only.
Maintenance
Clean the dust accumulated on the condenser, which is on the back part of your device with the help
of a vacuum cleaner or a dry brush after unplugging the device. Repeat this process a few times in a
year.