Ugur UDD 1600 D3KL NF - Page 7

User Manual |
7
EN
A- THINGS THAT MUST BE DONE BEFORE USING YOUR PRODUCT
AND SECURITY WARNINGS
WARNING!
• Do not place your product to a place exposed to drect sunlght or nuence area of the heat
sources such as stove, radator core, oven, cooker, radant and nfrared. Otherwse, ths may cause
performance decrease, damage of your product or make t become dysfunctonal (Pcture 1).
• Your product s set for operatng at mans power of 220-240V/ 50-60 Hz, 110-127/60 Hz Usng your
product wth a derent voltage may cause t become dysfunctonal and fre (Pcture 2).
• Our company s not responsble for the falures and materal damages that may occur n case of
usng wthout groundng.
• Electrcal nstallaton must conform to natonal regulatons.
• There must absolutely be a resdual current relay and a fuse n your electrcal nstallaton for
preventng the rsks of electrcal shock and fre.
• Place the devce n a damp-free place wth unobstructed ar crculaton.
• You must clean nsde your product before the frst use.
• After placng your devce to ts place, wat for one (1) hour wthout movng t before startng usng.
• If your devce s nstalled under very cold weather condtons, then the watng perod must be at
least two (2) hours before startng to operate t.
• In case of prolonged blackouts, do not open the door of your products for preventng heat loss.
• If you do not use your devce or leave t empty for a short tme, do not unplug t for savng energy.
Otherwse, more energy wll be consumed for re-coolng your product.
• In products, the doors of whch are left opened or opened and closed contnuously, frost depost
wll ncrease and no coolng operaton wll be carred out. Thus open the doors of your product
only when needed. Make sure that the doors are closed f not requred.
• Unplug your product n case of sudden blackouts. For startng agan, plug n your product 20
mnutes after the electrcty s suppled. Hgh voltage occurrng at the moment of electrcty supply
may cause damage of your product and fre.
• Do not allow wld anmals and pets to enter nto your product or walk around t. It may damage
your product or cause death and njury of the anmals. Furthermore, wld anmals and pets may
cause fre by gvng harm to the electrcal nstallaton.
• Your devce does not have any sterlzng eect on the mcroorgansms. Therefore t s necessary
that the foodstu you place nto your product must conform to the hygene standards and
packaged. Otherwse, mcroorgansms reproducng n foodstu may pose a threat for your health.
PICTURE 1 PICTURE 2
220-240V/ 50-60 Hz,
110-127/60 Hz