UHP NETWORKS UHP-200 User Manual

UHP-200 HIGH-THROUGHPUT SATELLITE ROUTER
GENERAL DESCRIPTION AND INSTALLATION GUIDE, v3.2
© UHP NETWORKS INC 2015 14 www.uhp.net
YOU HAVE TO LOG OUT FROM THE TERMINAL PROGRAM AND LOG IN AGAIN. YOU CAN AVOID THIS BY CUTTING OFF THE
SESSION BY “HANG-UP” COMMAND AND ONLY THEN RESTART THE ROUTER USING RESET BUTTON OR VIA POWER
SUPPLY CIRCUIT.
2.2.7 Remote Telnet access
Remote access to the configuration can be performed using Telnet protocol. The connection can be provided to
any of IP addresses that are set on the router. UHP-200 supports simultaneously only one Telnet session. In order
the hang session does not block access to the device forever in case on non-activity (pressing ENTER key), the
router auto-terminates the session after a certain time of inactivity. The time can be set in the configuration, and
by default it is 10 minutes.
2.2.8 Command Interface
Please refer to the Command Interface manual applicable for the respective version of SW and activated mode of
operation of the UHP router. The Command Interface manuals are available for download and online use on
Romantis website: http://www.uhp.net.

UHP NETWORKS UHP-200 Specifications

General

Brand	UHP NETWORKS
Model	UHP-200
Category	Network Router
Language	English