Ulthera, Inc. Page 63
N
Code N
USB flash memory connectiv ity
Please check flash driv e and
continue.
See User’s Manual for further
information.
A problem was detected with the
attached USB flash memory driv e.
Make sure the driv e is properly
formatted and has enough free space.
Do not remov e the driv e while the
system is communicating with it.
O
Code O
The system scanning is disabled
because of multiple Code Ms.
Please contact Ulthera Support
The system has experienced multiple
Code M’s and has been locked from
further use. This is to allow for further
assessment by Ulthera in order to
minimize risk.
P
Code P
Hardware halted
Please restart the system.
If the problem persists please
see the User’s Manual for further
information or contact Ulthera
Support.
Hardware was halted due to an ev ent
detected in the control unit.
S
Code S
The red STOP button has been
pressed.
Please restart the system.
If the problem persists please
see the User’s Manual for further
information or contact Ulthera
Support.
The red Stop button was pressed.
T
Code T
Internal transducer temperature
is too high
If the problem persists please
see the User’s Manual for further
information or contact Ulthera
Support.
The internal transducer temperature is
abov e its limit. Allow the transducer to
cool down or use another transducer.
U
Code U
Control unit temperature too
high
If the problem persists please
see the User’s Manual for further
information or contact Ulthera
Support.
The internal control unit temperature is
abov e its limit. Allow the control unit to
cool down. Prov ide proper v entilation.
To Next Page
Loading...